5.2. Digital TV Conditional Access Interface

Note

This documentation is outdated.

This document describes the usage of the high level CI API as in accordance to the Linux DVB API. This is a not a documentation for the, existing low level CI API.

Note

For the Twinhan/Twinhan clones, the dst_ca module handles the CI hardware handling. This module is loaded automatically if a CI (Common Interface, that holds the CAM (Conditional Access Module) is detected.

5.2.1. ca_zap

A userspace application, like ca_zap is required to handle encrypted MPEG-TS streams.

The ca_zap userland application is in charge of sending the descrambling related information to the Conditional Access Module (CAM).

This application requires the following to function properly as of now.

  1. Tune to a valid channel, with szap.

eg: $ szap -c channels.conf -r “TMC” -x

  1. a channels.conf containing a valid PMT PID

eg: TMC:11996:h:0:27500:278:512:650:321

here 278 is a valid PMT PID. the rest of the values are the same ones that szap uses.

  1. after running a szap, you have to run ca_zap, for the descrambler to function,

eg: $ ca_zap channels.conf “TMC”

  1. Hopefully enjoy your favourite subscribed channel as you do with a FTA card.

Note

Currently ca_zap, and dst_test, both are meant for demonstration purposes only, they can become full fledged applications if necessary.

5.2.2. Cards that fall in this category

At present the cards that fall in this category are the Twinhan and its clones, these cards are available as VVMER, Tomato, Hercules, Orange and so on.

5.2.3. CI modules that are supported

The CI module support is largely dependent upon the firmware on the cards Some cards do support almost all of the available CI modules. There is nothing much that can be done in order to make additional CI modules working with these cards.

Modules that have been tested by this driver at present are

  1. Irdeto 1 and 2 from SCM

  2. Viaccess from SCM

  3. Dragoncam